FSR DV-HXT-2 - Manual (Page 9)

9
Troubleshooting
The DV-HXT-2 Extender is designed for years of trouble free service, please
reference the troubleshooting chart below if experiencing issues with the device.
Problem Solution
No picture (or
signal)
1. Ensure the power LED is illuminated.
2. Check if TX or RX module is properly connected to
sources
or displays.
3. Check if UTP cable is properly connected for RGB & DDC
4. Check if EQ switch is correctly set up (rotary control
switch set to correct number)
5. Re-boot source device after the connection of UTP cables.
6. Check for proper termination of the CAT 5e/6 cables.
(Refer to the Technical specs).
Poor picture or
noise 1. Restart the system
2. Turn off DC power adapter, disconnect UTP cable,
reconnect the cables and power on.
3. Check for proper electrical grounding for HDMI Devices
4. Check if EQ switch is correctly set up (rotary control
switch set to correct number)
5. Set the resolution 720p/1080i at source manually