GAI-Tronics 226-003 S.M.A.R.T. Phones with Keypads User Manual
Page 8
Pub. 42004-349F
S.M.A.R.T.
P
HONES WITH
K
EYPADS
P
AGE
7 of 21
f:\standard ioms - current release\42004 instr. manuals\42004-349f.doc
04/09
Model 246-003
1. Remove the four screws from the front panel. Remove the front panel and set aside.
N
OTE
: There is a 7-foot half-modular telephone cord attached to the PCBA on the rear.
2. There are four mounting holes in rear enclosure. Mount the enclosure to the wall using either four ¼-
20 machine screws with washers and nuts or four #14 wood screws of the appropriate length,
depending on the mounting surface.
3. Drill a 0.688-diameter hole at either drill spot on the bottom of the rear enclosure, and attach the
gland bushing.
4. Fish the free end of the telephone cord through the gland bushing.
5. Replace the front panel assembly and tighten the four front panel screws.
6. Connect the free end of the half-modular telephone cord to the incoming subscriber line using a
USOC RJ11C jack (USA) or CA11A jack (Canada). Verify operation by calling to and from another
phone.
Figure 6. Model 246-003 S.M.A.R.T. Phone