GAI-Tronics 293-101 Externally Powered ADA-Compliant Emergency Phones - Manual (Page 18)

Pub. 42004-378C
E XTERNALLY P OWERED ADA-C OMPLIANT E MERGENCY P HONES P AGE 17 of 28
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-378c.doc
08/06
For Models 294-101AL, and 298-101, the procedure is as follows:
1. Disable the password protection feature—insert the J9 jumper on pins 2 and 1.
2. Press the C ALL push button. A dial tone is broadcast over the speaker. Simultaneously press 1 and #
on the phone keypad. The telephone generates a splash tone followed by a success tone.
3. Enter the desired programmable parameters. See the Programming Sequences section below.
A success tone (single tone [DTMF #]) tone is generated each time a new parameter is accepted. An
error tone (double beep) is generated to indicate an error. If an error tone is generated, verify the
programming sequence is correct, and enter the sequence again.
N OTES :
• The telephone is off-hook during local programming. Therefore, programming should be
completed quickly to avoid any off-hook timeouts controlled by the CO or PBX.
• The telephone automatically times out if 20 seconds elapse between digit entries.
4. Terminate the programming by pressing the C ALL push button.
5. Enable the password protection feature—insert the J9 jumper on pins 3 and 2.