Strobe installation – GAI-Tronics 234SBM Stanchion Broadcast Module User Manual
Page 4
Pub. 42004-416A
Model 234SBM Stanchion Broadcast Module
Page: 4 of 5
f:\standard ioms - current release\42004 instr. manuals\42004-416a.doc
10/08
Strobe Installation
Before installing the antenna kit, mount the strobe according to the instructions below.
1. Insert the new strobe’s seven 15-foot wires through the stanchion module’s threaded nipple (center
hole), and through the threaded nipple on the existing stanchion. Allow the wires to extend to the
base of the stanchion. See Figure 2.
N
OTE
: Wire lengths may need to be extended prior to feeding them through the threaded nipples.
Figure 2.
2. Screw the strobe onto the threaded nipple.
3. Separate the orange and violet wires necessary for the telephone connection, and extend those wires
through the stanchion cutout for the telephone; or extend the wires down to the opening for the access
panel in the rear of the stanchion body for connection to the paging module.