GAI-Tronics 352-701 UL Class 1 Division 1 VoIP Telephones - Manual (Page 11)

Pub. 42004-456C
Model 352-701 and 352-703 Division 1 VoIP Telephones Page 11 of 20
f:\standard ioms - current release\42004 instr. manuals\42004-456c.doc
02/15
Table 3. Recommended Cabling
Cable Use Size
LAN Cat5 or Cat5e UTP cable with an RJ45 connector
Power Two-conductor, No. 22 AWG is typical
Inputs Two-conductor, No. 22 AWG is typical
Output contacts Two or three-conductor, No. 18 AWG is typical
Speaker Two or three-conductor, No. 18 AWG is typical
Status Indication
Power
The Power LED located on the VoIP PCBA illuminates when power is applied to the telephone.
Heartbeat
The Heartbeat LED located on the VoIP PCBA will flash once communication over the LAN is
established.
EACT
The EACT LED located on the VoIP PCBA will turn on when the VoIP PCBA is connected to an
Ethernet device and flash when data is being transmitted.
Figure 11. VoIP Carrier PCBA Component Locations