GAI-Tronics 10959-908 Rack-Mount Audio Messenger Interfaces - Manual (Page 15)

Pub. 42004-487A
M ODEL 10959-906 & 10959-908 R ACK -M OUNT A UDIO M ESSENGER I NTERFACES P AGE
13 of 18
f:\standard ioms - current release\42004 instr. manuals\42004-487a.doc
01/14
Time Set Up
Push buttons on the top edge of the Main PCBA of the unit allows for date set up. Complete the
following procedure to set the date.
• Press <ENTER>, PB4, to enter the menu system.
• Press <SELECT>, PB3, to scroll to the TIME: display.
• Press <ENTER>, PB4, to enter the TIME set up.
• Press <ENTER>, PB4, to confirm choice.
• Press <UP>, PB1 or <DOWN>, PB2 to select the desired hour.
• Press <SELECT>, PB3, to scroll to the minute.
• Press <UP>, PB1 or <DOWN>, PB2 to select the desired minute.
Operation
Once the CompactFlash ® is programmed and installed into the unit, the unit operates based on system
inputs and outputs or by manual operation.
LCD Display at Initial Power Up
At initial power up, the AMI unit completes a self-diagnostic of its settings. The LCD display cycles
through the following messages:
• AMI firmware version
• Boot DSP
• Media detected
• EEPROM firmware version
• DSP firmware version
• Progress bar/LOAD CONFIG
• Configuration version
• Configuration date and time
• Configuration file name
• “HIO not installed.”
• “ASM not installed.”
• Page/Party
® board firmware version
• AMI Main board firmware version
• Telephone Interface Mode
• Telephone Interface Board firmware version
• Telephone Interface Greeting file name (if recording a new greeting)
• AMI ready
• Time, page symbol/date