GAI-Tronics 701-905 SmartSeries Handset/Speaker Amplifier - Manual (Page 8)

Pub. 42004-685L2D
701-905 S MART S ERIES
®
H ANDSET /S PEAKER A MPLIFIER P AGE 7 of 15
f:\standard ioms - current release\42004 instr. manuals\42004-685l2d.doc
03/12
Optional Features
The following features are available as options to the standard configuration of a station used in an
ADVANCE system and installed in a standard SmartSeries
® or a custom enclosure. These features can
be configured. Contact the GAI-Tronics Field Service Department at 800-492-1212 inside the USA or
610-777-1374 outside the USA for further information about these features.
 The Selected Page Destination feature allows the manual selection of one of four page destinations.
 The Supervised Input feature allows the monitoring and supervision of one or two initiating device
circuits (IDCs), initiating an alarm when the supervised device is activated.
 The Power Relay Module provides a relay contact output, typically to switch power to a visual
signaling device, for directed or relay group operation. Supervision of the controlled device’s cable
can also be enabled.
 The Station Emergency Party Line feature supports annunciation for two party lines.
Maintenance
Regular inspection and a good preventive maintenance program will increase the reliability of your
GAI-Tronics station. The GAI-Tronics Field Service Department can formulate a service contract suited
to your facility’s specific need for preventive maintenance.
If the equipment requires service, contact your Regional Service Center for a return authorization number
(RA#). Equipment should be shipped prepaid to GAI-Tronics with the return authorization number and a
purchase order number. If the equipment is under warranty, repairs will be made without charge. Please
include a written explanation of all defects to assist our technicians in their troubleshooting efforts. Call
800-492-1212 for help in identifying the Regional Service Center closest to you.
WARNING
Before performing any of the following preventive maintenance steps, remove
all power from the station.
1. Inspect and replace frayed or cracked wiring.
2. Secure/replace loose wires and spade terminals.
3. Remove corrosion from terminals.
Fuses
WARNING
Do not remove fuses when energized. Replace with the same type and size fuse.
F1 = T.160A, 250V, 5 20mm, IEC 60127-2.
F2 = T.630A, 250V, 5 20mm, IEC 60127-2.
F3 = T.125A, 250V, 5 20mm, IEC 60127-2.