DeLonghi PACL90 - Manual (Page 5)

5
The instructions below will enable you to prepare your air conditioning unit for operation as effi-
ciently as possible.
Before use, make sure the air intake and outlet grilles are unobstructed.
NON PERMANENT INSTALLATION
Just a few simple steps and your comfort is
ensured with Pinguino:
• Fit the air exhaust hose in the housing
at the back of the appliance. Insert it as
shown in figure A.
In order to improve the performance of the
appliance in air conditioning and boost
(super-conditioning) modes, you can also fit
the intake hose accessory
in its housing in
the back of the appliance as shown in figure
A1. This step is optional.
18
6
11
• Fit the window outlets to the end of
the hose / .
• Place the air conditioning unit near a win-
dow or French window.
• Make sure the air exhaust hose is unob-
structed.
18 11
12
I n s t a l l i n g y o u r p o r t a b l e
a i r - c o n d i t i o n e r
C
Keep air hoses as short and free of cur-
ves as possible to avoid constrictions.
ELECTRICAL CONNECTIONS
Before plugging the appliance into the electrical socket, check that:
•
the power supply corresponds to the value indicated on the rating plate on the back of the appliance;
• the socket and electrical circuit are adequate for the appliance;
• the socket matches the plug. If this is not the case, have the plug replaced;
• the socket is adequately grounded. Failure to follow these important safety instructions absolves the manu-
facturer of all liability.
The power cord must be replaced by a qualified professional only.
1
2
A A1
C1
French window
Sash window
For optimum results:
• If you have a sash window, place the
bracket or according to your
needs, on the window sill, extend the
bracket fully within the window frame, fix the
bracket by using the pin then lower the win-
dow onto the bracket. Insert the window
outlet
of the exhaust hose into the
slot, then connect the hose to the air condi-
tioner (fig. B and B1).
Thanks to the locking pins, it’s possible to use
the window bracket also for sliding windows.
Position the hole of the bracket so to allow a
correct installation of the exhaust hose.
11 12
17 16
B1 B