Dynex DX-G1113 - Manual (Page 64)

64 Installing your car stereo
Pontiac
Fiero 1984-1988
To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the four star-drive screws from the dash trim bezel.
3 Carefully pull out on the trim bezel, then remove it.
4 Remove the four hex-head screws from the factory head unit, then disconnect the
wiring.
5 Remove the hardware that secures the factory mounting brackets to the factory head
unit. Remove and retain the brackets.
6 Go to “Completing the installation” on page 76.
2
S10 shown
as example
DX-G1113.fm Page 64 Wednesday, August 16, 2006 3:38 PM