Connecting the receiver module (neo-fiberlink-2rx), Start-up – Guntermann & Drunck NEO-FiberLink2 User Manual
Page 9
Start-up
NEO-FiberLink-2 · 6
Connecting the receiver module (NEO-FiberLink-2Rx)
Place the receiver module close to the slave matrix switch.
Transmission – Tx:
Insert the LC plug of the fibre optics, which is available as acces-
sory. Connect the other end of the cable to the Transmission – Rx interface of the
receiver module.
Transmission – Rx:
Insert the LC plug of the fibre optics, which is available as acces-
sory. Connect the other end of the cable to the Transmission – Tx interface of the
receiver module.
Transmission-1 CAT:
Use a CAT5 (or better) twisted pair cable to connect these inter-
faces to a CPU interface of the master matrix switch.
Transmission-2 CAT:
Use a CAT5 (or better) twisted pair cable to connect these inter-
faces to a CPU interface of the master matrix switch.
Red. Power:
If necessary, connect the connection cable of the optional power pack to
this interface. Then connect a power cable to the power pack and a power outlet.
Main Power:
Insert the supplied power cable and connect it to a power outlet.
Start-up
Turn on the master and the slave matrix switch as well as the transceiver and
receiver module of the NEO-FiberLink series.
Main
P
ower
Red. Power
Transmission-1 CAT
Transmission-2 CAT
to master / higher-level device
Rx
Tx
Transmission Fiber
Class 1 Laser Product