Dolby Laboratories 585 - Manual (Page 25)

Model 585 Time Scaling Processor Time Scaling
3-3
When a clip is stored in the Model 585 memory, the Play menu displays the scaled
time value of that clip. If you change the scaling percentage, the length of the scaled
clip changes to reflect that, and the
Play menu display, In point, and Out point all
update accordingly.
Stop/Play
In the Play menu, Setup acts as a Stop/Play toggle. When you enter the Play menu,
Model 585 is in stop mode. When you press Setup in stop mode, playback of the clip
starts. If no In point or Out point has been set, playback starts at the current transport
position and continues until you press
Setup again, or until the clip ends. When the
clip ends, stop mode reactivates. When an In point or Out point is set, the Stop/Play
command functions as described under those headings in this section.
Scaling Percentage
When you enter the % menu, you see:
Orig. 00:30.00
+10.0% 00:33.00
Enter Setup Setup
Status
The screen values shown here are only an example.
The upper line shows the length of the original clip. The second line shows the
scaling percentage and the resulting length of the scaled clip. You can adjust the
scaling percentage in this menu using the arrow buttons, or by rotating the knob. As
you change the scaling percentage, the display for the length of the scaled clip
updates.
Scaling changes are applied immediately in this menu. If you are playing a clip, it
continues playing at the new scaling percentage.
Note: You can only exit the Scaling Percentage menu by pressing Esc . If you select
Bypass , playback stops.