Dolby Laboratories 585 - Manual (Page 6)

Model 585 Time Scaling Processor
vi
Regulatory Notices
USA
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with this instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his or her own expense.
WARNING: Troubleshooting must be performed by a trained technician. Do
not attempt to service this equipment unless you are qualified to do so.
Check that the correct fuses have been installed. To reduce the risk of fire,
replace only with fuses of the same type and rating.
Exposed portions of the power supply assembly are electrically “hot.” To reduce risk of electric
shock, the power cord must be disconnected when the power supply assembly is removed.
The ground terminal of the power plug is connected directly to
the chassis of the unit. For continued protection against
electric shock, a correctly wired and grounded (earthed) three-
pin power outlet must be used. Do not use a ground-lifting
adapter and never cut the ground pin on the three-prong plug.
WARNING: Before applying power, check the main fuse using the procedure on
page viii.
Canada
This Class A digital apparatus complies with Canadian ICES-003.
EU
This equipment complies with the EMC requirements of EN55103-1 and EN55103-2 when
operated in an E2 environment in accordance with this manual.
UK
Use power cord Dolby part number 92031 supplied with unit (pre-fitted with 13A plug to
BS1363) to connect Model 585 to the mains supply. This equipment must be earthed.