Dolby Laboratories JLE42BC3500 - Manual (Page 21)

19
ENGLISH
Auto Scan
Select the Signal Type of your TV input
and start auto scan.
Signal Type: Cable
Start Scan
Change Move Select OK Exit INFO Previous Setup RETURN
7
Press OK to start channel scan.
Scanning
Channel scan in process, if you want to stop
scanning, please press "Stop Scan".
Scan Status:
0%
Analog Channel:
Digital Channel: 0
0
Stop Scan
Select OK
Note:
t
Scanning may take some time to complete.
t
Select Stop Scan to cancel the auto scan at anytime.
8
When auto scan is complete, press OK to
continue.
Scan Finish
Channel scan completed.
Analog Channels:
Digital Channels: 12
26
OK
Select OK Exit INFO Previous Setup RETURN
Exit Retail Mode
1
Press RETURN.
2
Press or to select “OK”, then press OK to
confirm.
Do you wish to exit Retail Mode?
Cancel OK
Basic TV Operation
Changing Channel
Press the number buttons to directly select
channels.
Note: After pressing the number buttons, there will be
a few seconds delay before the TV changes channel. To
change to the channel right away, press ENT after pressing
the number buttons.
To Browse Channel
Press the Channel up/down buttons on the
remote control or
CH , CH on the TV to
increase or decrease the channel.
CH
Press to scroll through the
channels manually.
To Select Analog Channels
1~9 Press 1~9 as needed. Example,
to select channel 2, press 2, then
press ENT.
10~99 Press the 2 digits in order.
Example, to select channel 15,
press 1, 5, then ENT.
100~135: Press the 3 digits in order,
Example, to select channel 130,
press 1, 3, 0, then press ENT.
Basic Operations