Hoefer PCR1000 - Manual (Page 14)

•
p3
Installation and Operation of
the PCR Workstation
A. Installation
1. Check the cabinet and power cord for any damage.
DO NOT use if the system shows any sign of
damage.
2. Place the cabinet on a flat surface, using a safety
tray if required.
3. Connect the power cord into the back of the
cabinet and insert into an grounded mains socket.
B. Using the UV Lights
1. Place the objects to be sterilized inside the
cabinet and close the side doors.
2. Switch the ‘Power’ switch to the ON position.
3. Turn the timer to the required time. Twenty
minutes is sufficient time to sterilize most pieces
of equipment. The UV lights will automatically turn
on and then switch off after the set time.
4. If the UV lights are required to remain permanently
on, then switch the UV light switch to the ON
position. This will override the timer.
C. Using the White Lights
1. Switch the ‘Power’ switch to the ON position.
2. Switch the ‘White Light’ switch to the ON position.
Note: The UV lights will not
operate when the doors are
open.
Note: The white lights are not
operated by the timer switch
and will remain on when the
doors are open.