Tools required – Hoist Fitness HD-1400 User Manual
Page 3
Page - 2
HD1400 Assembly
I N S T R U C T I O N S
Socket Wrench
(9/16”, 1/2”)
3/4" Open End Wrench
Standard Allen Wrench set
(5/64” thru 1/4”)
Crescent Wrench
Rubber Mallet
Tape Measure
External snap ring pliers with a
tip size between .035" ~ .043".
TOOLS REQUIRED
Before beginning assembly please take the time to read the
instructions thoroughly. Please use the various lists in this
manual to make sure that all parts have been included in your
shipment.
Use only Hoist replacement parts when servicing.
Failure to do so will void your warranty and could result in
personal injury.
Hoist equipment is designed to provide the smoothest, most
effective exercise motion possible. After assembly, you should
check all functions to ensure correct operation. If you
experience problems, first recheck the assembly instructions to
locate any possible errors made during assembly. If you are
unable to correct the problem, call your authorized Hoist dealer.
Be sure to have your serial number and this manual when
calling. When all parts have been accounted for, continue on .
When ordering use the part number and description
from the lists.
OW N E R S
M A N U A L