ikan PT2100 - Manual (Page 12)

3903 Stoney Brook Dr. Houston TX 77063 | +1.713.272.8822 | www.ikancorp.com | [email protected] | © 2009 ikan Corporation. All right reserved.
F.A.Q.
ikan PT2100 TELEPROMPTER
Q: I was told that the PT2100 monitor can be powered by a professional battery adaptor. What part do I need
to order?
A: The correct part designation for the Pro Battery Kit that you will need to order is the PBK2100-S (V-Mount)
or the PBK2100-A (Gold Mount). These parts can be found by clicking on the Accessories tab above.
________________________________________________________________________
Q: I recently purchased a PT2100 and the User Guide does not match what I received in the box.
A: Some early models of the PT2100 were shipped with the previous version’s User Guide.
You can download the newly revised PT2100 User Guide at www.ikancorp.com.
________________________________________________________________________
Q: I have assembled my PT2100 and I have some parts left over. What do these belong to?
A: First, you can double-check the assembly of the PT2100 to verify that each piece is in its correct placement.
Then, you can refer to the parts listing. There are two (2) larger pieces included which are “Optional” bracketry
and not necessary for the operation of the PT2100. These are Part O: 8” T-Slot with Metal Bracket and Part R:
100mm Mounting Bracket. These pieces are included as a convenience to the user (for Part O) and for usage
with optional, separately purchased accessories, such as the Pro Battery Plates (for Part R).
Section 8B of the User Guide can guide you through the assembly of Part O.
Part R can be mounted once the entire assembly has been built. It will slide on to the end and serves as the
bracket for a separately purchased Pro Battery Plate. When mounted with the Plate and a Pro Battery, this
can also help serve as a counter-balance for the rear of the teleprompter.
_______________________________________________________________________
Q: Will my PT2100 work with the Ikan Pro Battery Packs?
A: Yes. The monitor used for the PT2100 is the V8000, which can take 12-24 volts. This will allow for
compatibility with the V-Mount or Gold Mount Pro Batteries and most power systems.
_______________________________________________________________________
Q: How do I flip the image on my PT2100 monitor?
A: There is a detailed instruction sheet to flip the image on the PT2100 monitor which can be downloaded
at www.ikancorp.com.
_______________________________________________________________________
Q: How do I set-up my computer for the PT2100?
A: There is a detailed Quick Start Guide which can be downloaded at www.ikancorp.com with instructions
on setting up your computer for the PT2100.