Slider – ikan SLD-01 User Manual
Page 6
Advertising
Slider
QUICKSTART GUIDE
www.ikancorp.com
713-272-8822
VERTICAL CONFIGURATION
4. Setting up your Slider in a vertical configuration will require the 1.285” 3/8-16 Thumb
Screw. First, stand your Slider up vertically so that the 3/8-16 hole is on top. Next,
allign the center hole on both your Tabletop Feet so that the two sets of feet
intersect with one another. Insert the 3/8-16 Thumb Screw through both sets of
Tabletop Feet and into the Slider Body, and tighten for a secure fit. Finally, stand
your Slider up vertically by flipping it over. Ensure proper balance by using the level
located at the bottom of your Slider and adjusting individual feet.
Advertising