DeLonghi CT300H - Manual (Page 10)

28
SETTING THE TIMER
The programmer/timer, like all clocks, must be set to the
exact time. If for example it is 4:00 p.m. (16.00), turn the
dial in a clockwise direction (following the direction of the
arrow) until the number 16 is lined up with the triangular
pointer (the arrows indicates 4:00 p.m. approximately ).
Note: Never turn the dial in an anti-clockwise direction!
The timer is in effect, an electric clock and works only if the
plug is connected to the power supply. Whenever the
plug is disconnected or there is a power failure, the
programmer stops (the clock is then “slow”) and must be
re-set.
The unit can be used in either programmed or non-
programmed mode.
PROGRAMMED MODE
1) Position the timer switch in the TIMER ON position (the
TIMER ON/OFF warning light on the control panel will
light up).
2) Set the operating times by pushing out the notches on
the dial corresponding to the period required (each
notch represents 15 mins.)
3) Check that the timer indicates the correct time (see
instructions on setting).
4) Select the desired function as shown in the chart
overleaf.
The unit will now switch on and off each day at the
selected times.
NON-PROGRAMMED MODE
CONTROL PANEL (Mod. CT300H)
Timer notches
21
20 19
16
arrow pointer
21 20 19
16
Funzionamento Operating time
ON/OFF button ON/OFF pilot light
Timer ON/OFF pilot light
Heating pilot light
air-conditionig/
heating button
Selecting fan
speed button
Thermostat
TIMER ON/OFF BUTTON
In case the programmed functioning is not desired, it is
not necessary to vary the program; in this case, it will be
sufficient to turn the TIMER to the OFF position.
A
B C