JayBird JBBA100m - Manual (Page 4)

ENGLISH
Pairing the adapter with your JayBird
Bluetooth ® Stereo Headset
1. Before pairing, make sure that your headset is turned off (no flashing blue
LED through the right side logo).
2. Put the headset into pairing mode by pressing the POWER/TALK button
on the headset for 5 seconds until the LED on the right earpiece begins
blinking alternating red and blue colors.
3. Remove the adapter from the Charger Dock.
4. Press the button on the adapter for a few seconds until the LED flashes.
The adapter LED will blink once every three seconds while in search
mode.
5. Once the headset finds and pairs with the adapter, both the adapter and
headset LEDs will blink blue once every six seconds. Your headset and
adapter are now paired.
Listening to Music
1. Plug the 3.5mm audio connector into the headphone jack on your MP3
player (or any stereo audio device with a 3.5mm headphone jack).
2. Confirm that your adapter is paired with your headset and that both are
turned on. The LED on the adapter and on the headset should both be
blinking blue every six seconds. If the LED is not blinking on your adapter,
turn it on by pressing the button on the adapter for a few seconds until
the LED start flashing.
3. Turn on your MP3 or other device and play music. You should now hear
the music on your headset.
4. You can change the volume level by using your UP/DOWN volume buttons
on the headset. You can also change the volume by using the volume
controls on your MP3 player. It’s a good idea to find an acceptable volume
on the MP3 player and is not a good idea to use full volume on the MP3
player as this may distort the sound quality. Set the volume once on your
MP3 player and use the headset UP/DOWN volume buttons for adjusting
the volume levels.
5. Be sure to turn off the adapter after use by pressing the adapter button
for a few seconds. The LED will flash blue when turning off the power.
The LED will completely turn off when the adapter is turned off.
Using the phone call feature of your JayBird
Bluetooth ® Stereo Headset
1. The JayBird Bluetooth ® Stereo Headset can also be paired with any
compatible Bluetooth ® enabled mobile phone. For pairing instructions,
refer to the user manual that came with your headset.
For a list of compatible A2DP enabled phones please visit www.jaybirdgear.com/phones
3