Jetway Computer NAF92-Q67 - Manual (Page 28)

24
Serial-ATA Controller 0
The optional settings are: [Disabled]; [Enhanced]; [Compatible].
Serial-ATA Controller 1
The optional settings are: [Disabled]; [Enhanced].
► Intel IGD SWSCI OpRegion
IGD-Boot Type
Use this item to select the video device which will be activated during POST. This
has no effect if external graphics present.
Active LFP
Use this item to select the Active LFP Configuration.
LCD Panel Type
Use this item to select the LCD panel used by internal graphics device.
► USB Configuration
Legacy USB Support
The optional settings are: [Auto];[Disabled]; [Enabled].
EHCI Hand-off
The optional settings are: [Disabled]; [Enabled].
USB Transfer time-out
Use this item to set the time-out value for control, bulk, and interrupt transfers.
Device reset time-out
Use this item to set USB mass storage device start unit command time-out.
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor.
► Super I/O Configuration
Press [Enter] to enter into the sub-item.
► COM1 Port Configuration
Serial Port
Use this item to enable or disable serial port (COM).
Change Settings
Use this item to select an optimal setting for super IO device.
► COM2 Port Configuration
Serial Port
Use this item to enable or disable serial port (COM).
Change Settings