JLCooper Eclipse Series Joiner Kit - Manual (Page 8)

6. Attach both brackets to joiner metal with smaller screws and
the nuts, so that there is a bracket on each side of the joiner.
Be sure that the threaded holes of the bracket are facing up.
Secure screw and nut with the 1/16 inch hex driver and a 1/4
inch nut driver.
7. Arrange the two bottom panels in the desired configuration.
Place the Eclipse Series Joiner between the two bottom panels.
Align the three mounting holes in the bottom panel so that they
pass through the three mounting holes in the Eclipse Series
Joiner.
8. Attach the two bottom metal pieces to the joiner with three
supplied Philips head screw and nuts. Tighten until secure
using a #2 Philips screwdriver and 1/4 inch nut driver.
9. Replace the top metal for both units. During this time, it may
be possible pass the data and/or power cables between the units
by passing the cables through the two circular holes in the
Eclipse Series Joiner. Consult the documentation of the
specific Eclipse units or contact the JLCooper Service
Department.
8