Installation, Commandes et connecteurs, Promig 520r: module de commande – Kemppi Promig 520R User Manual
Page 5: Installatie, Bediening en aansluitingen, Promig 520r bedieningseenheid, Inbetriebnahme, Anschlüsse und steckverbindungen, Promig 520r steuerungseinheit, Operation control and connectors
Advertising
PROMIG 520R, 120R / 0544 – 5
© KEMPPI OY
2. INSTALLATION
2.1. OPERATION CONTROL AND CONNECTORS
2.1.1. Promig 520R control unit
Place for control panel
Lock switch of panel
(option for MXE model)
Wire inch
Gas purge
Motor overcurrent indicator
Holes for user connectors
Holes for gas snap connectors
Welding current output connector (+)
Control cable connector (to 120R or
voltage controlled wire feeder SWF)
Control cable connector (to 2nd 120R)
Robot controller connector
Control cable connector (Probus)
Voltage monitoring connector (–)
Connector for channel selection
(option for MXE model)
Hole for wire outlet connector
Fixed welding cable to Pro power source
Fixed control cable to Pro power source
Advertising
This manual is related to the following products: