Kemppi R11T - Manual (Page 3)

R11T/0236 – 3 ©
COPYRIGHT KEMPPI OY
1. PREFACE
1.1. INTRODUCTION
Congratulations on having purchased this product. Properly installed Kemppi
products should prove to be productive machines requiring maintenance at only
regular intervals. This manual is arranged to give you a good understanding of
the equipment and its safe operation. It also contains maintenance information
and technical specifi cations. Read this manual from front to back before
installing, operating or maintaining the equipment for the fi rst time. For further
information on Kemppi products please contact us or your nearest Kemppi
distributor.
The specifi cations and designs presented in this manual are subject to change
without prior notice.
In this document, for danger to life or injury the following symbol is used:
Read the warning texts carefully and follow the instructions. Please also study
the Operation safety instructions and respect them when installing, operating and
servicing the machine.
1.2. PRODUCT INTRODUCTION
R11T is transmitter part for remote control unit which is designed for MMA
welding with Master MLS power sources. Master MLS power sources have an
incorporated receiver as standard.
R11T is using welding cables for transfer of control information, longest
operating range is ca. 200 m. Receiver of power source converts transmitter
signal as current rated value and controls power source according to it
You can use wireless remote control unit with following power sources from
serial number *) on:
Master 1600 MLS (6102160): all serial numbers
Master 2500 MLS (6104250): from number 1071536
Master 3500 MLS (6104350): from number1066406
Mastertig 2000 MLS (6112200): all serial numbers
Mastertig 2500 MLS (6114250): from number 1064082
Mastertig 3500 MLS (6114350): from number 1066756
*) Note! You must replace the control card A001 into the machines,
manufactured before these.