Kemppi R11T - Manual (Page 4)

4 – R11T/0236 44 ©
COPYRIGHT KEMPPI OY
X2
R1
X1
H1
1.3. OPERATION SAFETY
Be careful for voltage! Between work piece
and connector X2 there is in adjustment
situation open circuit voltage of power
source, do not touch both at the same time.
Do not try to use remote control device with other power sources than
with those mentioned above! See to that cables you intend to use are
connected to right machine!
Be careful for not touching enclosure of remote control device with hot electrode!
Do not put control device onto hot work piece!
Do not throw or drop remote control device!
2. OPERATION
Power source
Turn selecting switch for remote/local control of power source into remote control
position.
Use of a remote control unit with cables is not possible at the same time with
R11T. Disconnect remote control unit with cables from power source’s connector.
Changing over to use remote control unit with cables is made by connecting remote
control unit with cables back to remote control connector.
R11T control transmitter
control electrode
potentiometer
earthing electrode
signal lamp