Optional features, Bleach dispenser fabric softener dispenser – Kleenmaid LWK23 Version 38903R6 User Manual

Page 16

Advertising
background image

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Use and Care

38903

14

Optional Features

Bleach Dispenser

The bleach dispenser is located in the left front corner,
under the loading door.

Use liquid bleach in the dispenser. Powdered bleach
must not be used in the dispenser. Add powdered
bleach to the wash water.

Use no more than one cup chlorine bleach for large
loads, three-quarters cup for medium and one-half cup
for small loads.

Carefully pour recommended amount of bleach into
the dispenser during the first fill of the washer.

Be careful not to spill undiluted bleach. It is a strong
chemical and can damage some fabrics if it is not
properly diluted.

Fabric Softener Dispenser

To Use Dispenser

After the clothes are loaded into the washtub and
before the start of the WASH cycle, pour the proper
amount of liquid fabric softener into the bottle
measuring cap (refer to bottle directions). Pour into
dispenser.

The large fabric softener dispenser allows for the
fabric softener to be diluted with water. We
recommend adding water up to the fill level. Do not
exceed tip of arrow, which indicates correct fill level.
Over-filling can allow fabric softener to spill onto the
clothes.

Setting the water level to medium or higher will result
in better performance from the fabric softener.

The fabric softener will remain in the dispenser during
the wash fill, agitation and spin. At the end of the wash
spin, the liquid fabric softener will be dispensed into
the washtub through the slots in the agitator and will
be mixed with the incoming rinse water.

To Clean the Dispenser

Remove the dispenser housing from agitator by
squeezing the lower part of the dispenser, pulling
directly upward and at the same time tilting slightly.
This will expose the dispenser cup, which is also
removable for cleaning (refer to Figure 9). Both
housing and cup can be soaked in hot soapy water and
rinsed clean. The funnel shape in top of agitator and
down the centre of the agitator also needs to be
cleaned. The hole and the slots in the two rings will
require using a small brush for proper cleaning.

After cleaning, install dispenser cup, then push
dispenser housing directly downward onto top of
agitator until firmly snapped together.

Use Tips

Fabric softener spilled onto garments may cause

staining. To remove, soak in a soapy solution
made from Sard Wonder Soap or rub the stain
with a bar of Sard, then wash.

Liquid fabric softeners will be dispensed during

the final rinse and should not be combined with
bleach, bluing, starch, detergents, soaps or
packaged water conditioners.

Fabric softener is not to be used in dispenser

when using Prewash cycle, if available.

When adding detergent to wash water, do not

allow any to enter into softener dispenser cup, as
softener will become gummy.

To prevent softener buildup, the dispenser can be filled
with clean water for automatic cleaning. This can be
done in washing cycles other than when softener is
used.

Figure 9

W284I

1

Dispenser Housing

2

Dispenser Cup

3

Agitator

W284I

1

2

3

Advertising