Kleenmaid LTKA6 - Manual (Page 23)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Washer Operation
21 802726
There are five WASH/RINSE temperatures available –
BOOSTED HOT WASH/COLD RINSE, HOT WASH/
COLD RINSE, WARM WASH/COLD RINSE,
WARM WASH/WARM RINSE, and COLD WASH/
COLD RINSE.
The ENERGY SAVER settings, marked with a dot (•),
show which temperature settings will use the least
energy.
Refer to the Available Water Temperatures section for
the temperature that works best for your garments.
6. Select EXTRA RINSE if desired.
Figure 11
The extra rinse control is useful for detergent
sensitive skin. By pressing the EXTRA RINSE to
ON, the REGULAR, PERMANENT PRESS,
and DELICATE cycles will each provide an
additional rinse. If the extra rinse is desired, press
the switch to ON. When the extra rinse is not
wanted, OFF should be selected.
7. Select the cycle according to the type of fabric
being washed. Use the indicator dot on the knob
as a guide.
Figure 12
8. Press and hold the START button for two seconds
to start the washer. The DOOR light will come on
after a short delay, water fill will begin, and wash
drum will begin tumbling.
NOTE: Washer door MUST be closed tightly to
start washer.
If items need to be added or removed after a cycle has
started, turn the Cycle Selector knob to the OFF
position. Wait until the DOOR light goes off
(approximately 45 seconds after cycle has been
stopped), open door, add or remove items, and start the
cycle again.
There is no agitator on this washer. Instead, the
clothing gently tumbles through the water. The wash
action consists of a period of tumbling in one
direction, a brief pause, and then a reverse tumble in
the opposite direction. The pauses are part of the
tumble action and add to the uniqueness of the washer.
They are part of the cycle.
NOTE: There will be extended pauses when
BOOSTED HOT wash is selected because the
water is being heated.
To Change Cycles
If the selected cycle is not the correct cycle for the
fabric being washed, you may change the cycle
selection at any time until the first wash fill is
complete. Once the washer has filled for the first part
of the cycle (the wash portion), the current cycle must
be aborted and a new cycle must be started.
To change the cycle before the first fill is complete:
Change the cycle selected on the cycle selector switch.
To change the cycle after the first fill is complete
and before the first wash is complete:
1. Abort the current cycle by changing the cycle
selector switch to the OFF position.
2. Set the WASH/RINSE temperature selector.
3. Set cycle selector.
4. Turn on extra rinse, if desired.
5. Press and hold the START button for two
seconds.
DRY2070N
DRY2071N
Window may be hot in the Boosted Hot and
Hot wash cycles.
W325
WARNING