Kleenmaid KED597-4350 - Manual (Page 16)

16
502522
Possible Reason —
Do This To Correct
Won't
Start
Won't
Heat
Doesn’t Dry
Clothes
Satisfactorily
Before You Call For Service . . .
(You may save time and money by checking the following:)
If Your Dryer:
Dryers equipped with power cord — be sure the power cord is
plugged all the way into the electrical outlet.
Close the loading door.
Turn timer knob further into the cycle, or try a different cycle.
Push timer knob in to start dryer.
Has the laundry room fuse(s) blown or become loosened, or are
circuit breakers open? The dryer itself does not have an electrical
fuse.
Has the motor overload protector cycled?
Is the FABRIC SELECTOR switch in a heat setting?
Gas Dryer Only — Check to see if main gas line valve is turned on.
Check exhaust duct to outside to see if kinked, blocked or needs
cleaning. (Timer may not advance in automatic cycle.)
Check weather hood to make sure flapper moves freely, has not been
pushed in or has not been blocked. (Timer may not advance in
automatic cycle.)
Automatic Cycle — Adjust to more or less dry setting.
Timed Cycle — Allow more or less time.
Clean the lint filter.
Is the load too small? Loads which are too small may not tumble
properly or dry evenly.
•
•
•
•
• •
• •
•
• •
(Electric
Dryers
only)
• •
•
•
•
•
•
If Service Is Required . . .
When calling or writing about your
dryer, PLEASE GIVE THE MODEL
AND SERIAL NUMBERS. The
model and serial numbers are
located on the nameplate in one of
the four corners of the door well.
The door well is the shaded area
shown.
Please include a copy of your bill
of sale and any service receipts
you have.
If service is required, contact the
nearest Factory Authorised
Service Centre.
If you are unable to locate an
authorised service centre or are
unsatisfied with the service
performed on your dryer, contact:
Kleenmaid
P.O. Box 36
Brookvale, NSW 2100
D154PE3A