Vertex Standard VX-261 - Manual (Page 20)

18 VX-261 O
perating
M
anual
a
dVanced
o
Peration
s
Peed
d
ial
Your Vertex Standard dealer may have pre-programmed
Auto-Dial telephone number memories into your radio.
To dial a number:
Press, (or press and hold), the assigned PF key to send a
pre-defined DTMF tone. The DTMF tones sent during the
dialing sequence will be heard in the speaker.
c
all
Press, (or press and hold), the assigned PF key to send a
pre-programmed 2-Tone encode code.
d
utY
Press, (or press and hold), the assigned PF key to toggle
the Duty function of the 2-Tone or 5-Tone “On” and “Off”.
When the Duty function is set to “On”, the user will al-
ways hear (depending on the sub-audio signaling) all traf-
fic on the paging channel. The radio will sound the paging
alert when it receives the programmed 2-Tone or 5-Tone.
When the Duty function is set to “Off”, the user will NOT
hear normal radio traffic on the paging channel. The radio
will sound the paging alert and unmute only when it re-
ceives the programmed 2-Tone or 5-Tone.
tx s
aVe
d
isable
The Transmit Battery Saver helps extend battery life by
reducing transmit power when a very strong signal from
an apparently nearby station is being received. Caution
is advised when using this feature, as your transmission
power could degrade the audio heard by the receiving ra-
dios in your communication path.
Press, (or press and hold), the assigned PF key to disable
the Transmit Battery Saver, if you are operating in a loca-
tion where high power is almost always needed.
Press again, (or press and hold again), the assigned PF
key, the Transmit Battery Saver activates to reduce the
transmit power when a very strong signal from an appar-
ently nearby station is being received.
l
ocK
Press (or press and hold) the assigned PF key to lock the
CH Selector knob, Programmable keys, and PTT switch.