Dometic RM2553 - Manual (Page 9)


REFRIGERATOR REMOvAL
Disconnect the 230- 240 V AC voltage and 12 V
DC voltage leads.
Shut off the gas supply at the LP tank.
Disconnect the gas supply line. Always use a
back up wrench when loosening and tightening
connections.
Cap the gas supply line, loosen the screws an-
choring the refrigerator to the enclosure and slide
the refrigerator out of the compartment.
When replacing the refrigerator make sure that
the sealing strips are properly positioned.
Replacement is the reverse of removal. Check all
connections for gas leaks.
1.
2.
3.
4.
5.
6.
To mount the door panel - snap in
Open the door 90 degrees.
Remove the door decoration
strip (2) by gently pushing the
four tabs away with a flat blade
screwdriver (1).
Insert the vertical edges
into the grooves of the door
frame (3).
Push the panel downward
so that the lower horizontal
edge of the panel (4) is fitted
into the bottom grove (5).
Snap in the decoration strip (2).
1.
2.
3.
4.
5.
1
2
2
3
3
4
5
INSTALLATION INSTRUCTIONS
Before leaving
Once the installation is complete, test the operation of the
refrigerator and instruct the user on it’s correct operation.
If the appliance fails to operate correctly, contact your local
Dometic Service provider.