La Crosse Technology WS-9215 - Manual (Page 4)

4
SET UP:
Note: This weather station receives only one outdoor transmitter.
Do not mix old and new batteries. Do not mix alkaline, standard, or rechargeable batteries.
1. First, insert the batteries into the temperature transmitter. (see “Install and replace batteries in the
temperature transmitter “).
2. Within 30 seconds, insert the batteries into weather station (see “Install and replace batteries in the
weather station ”). Once the batteries are in place, all segments of the LCD will light up briefly. Then the time
(default 12:00) and the weather icon will be displayed. If these are not displayed after 60 seconds, remove the
batteries and wait for at least 60 seconds before reinserting them.
3. After inserting the batteries, the weather station will start receiving data from the transmitter. The outdoor
temperature and the signal reception icon should then be displayed on the weather station. If this does not
happen after 3 minutes, the batteries will need to be removed from both units and reset from step 1.
4. In order to ensure successful 915 MHz transmission, this should under good conditions be a distance no
more than 200 feet/100 meters between the final position of the weather station and the transmitter (see
notes on “Mounting” and “915 MHz Reception”).