Lacava W1026 - Manual (Page 4)

LACAVA LLC
®
Page 4 of 10
Installation Instructions
1. Connect the water supply lines and the mounting screw to the body.
2. Place the rubber washer on the faucet hole of the mounting surface.
3. Place mixer body through the faucet hole of the mounting surface.
4. From below the mounting surface, slide the rubber washer, then metal washer,
extension, and the half moon plate onto the brass base of the mixer body.
5. Screw the locking bolt onto the brass base by hand until tight, and then turn an
additional ¼ turn using a wrench. Be careful not to over tighten the bolt, as this
may cause damage to the mounting surface.
6. Attach the supply lines to the faucet base and then connect them to the water
supply.
Replacement of the Aerator Cartridge
1. Pull the aerator (1) out of the spout (2). It is kept in place by a rubber washer.
2. Insert the new cartridge carefully; making sure that the sealing rubber washer is
not damaged.