LD Systems MAUI 28 MIX - Manual (Page 9)

13 INDICATOR LEDs
ON: Lights up once the system is switched on and properly connected to the power mains.
LOCKED: Special control electronics use this LED to indicate that all parts of the system are properly connected
after the system is turned on.
SIGNAL: Lights up as soon as an audio signal is present.
LIMIT: Lights up if the system is operating in the clipping range. Brief flashing is not a cause for concern,
since the internal audio limiter compensates for over-modulation. Permanent illumination should be avoided
by reducing the volume.
PROTECT: Lights up when one of the power amplifier protection circuits is active. To protect the power
amplifiers and the speakers, the speaker outputs are deactivated in protect mode. Once the source of the
trouble has been eliminated (e.g., overloading), after a short time, the power amplifier returns to normal
status, the Protect LED goes out, and the system is operational again.
14 POWER SOCKET
IEC power socket with built-in fuse holder.
IMPORTANT INFORMATION: Replace the fuse only with a fuse of the same type and rating. If the fuse blows
repeatedly, please contact an authorised service centre.
15 POWER
Illuminated on / off switch. Before switching the system on or off, always adjust the volume to zero (Main
Level all the way to the left).
CONNECTIONS, CONTROLS, AND INDICATORS:
9
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
DEUTSCH
ENGLISH