LD Systems MAUI 44 - Manual (Page 13)

Important notes about using the MAUI44SE subwoofer extension:
If PA subwoofer MAUI44SE subwoofer is to be used as stand-alone, set the
DSP MODE switch to the left position
MANUAL. The connectors LINE INPUT LEFT / RIGHT, and LINE OUTPUT LEFT / RIGHT can now be used to connect
playback devices and to control other speakers or amplifiers. Also, the SUB LEVEL, SUB FREQ and SUB PHASE
controls can be used for customised settings.
If the MAUI44SE subwoofer is used as an extension for the MAUI44 column system, set the
DSP MODE switch
to the right position SLAVE (MAUI44) and connect the line output SLAVE SUB OUT (MAUI44SE) of the MAUI44
column system with the line input SLAVE SUB IN (MAUI44) of the MAUI44SE subwoofer. If the switch is in SLAVE
position (MAUI44), the SUB LEVEL, SUB FREQ and SUB PHASE controls , as well as the left line input LINE INPUT
LEFT are disabled.
1 LINE INPUT LEFT / RIGHT
Unbalanced line input with 2 RCA phono jacks. An incoming stereo signal is mono summed internally. If
the MAUI44SE subwoofer is to be used as stand-alone PA subwoofer, set the DSP MODE switch to the left
position MANUAL.
2 LINE INPUT LEFT / RIGHT
Balanced line input with 2 female XLR / 6.3 mm jack (combo jack). An incoming stereo signal is mono summed
internally. If the MAUI44SE subwoofer is to be used as stand-alone PA subwoofer, set the DSP MODE switch to
the left position MANUAL.
3 SLAVE SUB IN (MAUI44)
Balanced line input with XLR / 6.3 mm jack (combo jack). If the MAUI44SE subwoofer is used as an extension
for the MAUI44 column system, optimal control is achieved by the MAUI44 column system in accordance
with the following steps: Move the DSP MODE switch to the right position SLAVE (MAUI44) and connect
the line output SLAVE SUB OUT (MAUI44SE) of the MAUI44 column system with the line input SLAVE SUB
IN (MAUI44) of the MAUI44SE subwoofer using a balanced XLR Cable. If the DSP MODE switch is in SLAVE
position (MAUI44), the SUB LEVEL, SUB FREQ and SUB PHASE controls , as well as the left line input LINE
INPUT LEFT are disabled. Now, the control of the volume on the subwoofer of the MAUI44 column system and
the MAUI44SE subwoofer is done via the SUB LEVEL controller on the MAUI44 column system.
4 LINE OUTPUT LEFT / RIGHT
Balanced line output with 2 male XLR connectors. The output signal corresponds to the input signal.
5 SUB LEVEL
Volume controller for the MAUI44SE subwoofer. If the DSP MODE switch is in position SLAVE (MAUI44), the
volume control SUB LEVEL is disabled.
6 SUB FREQ
Setting the upper cut-off frequency of the subwoofer from 80 Hz to 140 Hz. If the DSP MODE switch is in
position SLAVE (MAUI44), this feature is disabled.
CONNECTIONS, CONTROLS, AND INDICATORS:
13
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
DEUTSCH
ENGLISH