LD Systems LAX 3 USB - Manual (Page 9)

9 CD / tAPE IN L/R
The CD / TAPE input is for connecting an external sound source (e.g., CD player, tape deck, etc.).
Furthermore, it can also be used as a stereo line input, e.g., for connecting an additional LAX mixer.
10 CD / tAPE OUt L/R
The signal on the CD / TAPE output is the same signal that is present on the main output (MAIN
OUT). The level of the output signal is set using the MAIN MIX control.
11 MAIN OUt
Stereo 3.5 mm jack socket. The signal present here is the master mixer signal and/or the CD /
TAPE IN signal (see Item 18). The level of the output signal is set using the MAIN MIX control (14).
12 PhONES / CONtROL ROOM OUtPUt
Stereo 3.5 mm jack socket. The signal present here is the master mixer signal and/or the CD /
TAPE IN signal (see Item 19). The level of the output signal is set using the PHONES / CONTROL
ROOM control (16), but it is also dependent on the main mix control if CD / TAPE IN was not
selected as a signal source.
13 POwER LED
Lights up as soon as the mixer is connected to the power mains correctly (included power supply)
or is connected to the USB 2.0 port of a computer and is switched on.
14 MAIN MIX
Volume control for the stereo main mix signal of the mixer.
15 CLIP LEDS L/R
These LEDs light up as soon as the clipping threshold of the mixer is reached. If necessary,
reduce the volume in order to obtain distortion-free sound and avoid damage to connected
equipment (headphones, speaker systems).
16 PhONES / CONtROL ROOM
Volume control for the PHONES / CONTROL ROOM output.
17 LINE 2/3 / USB
If this button is not pressed, the signal present on LINE IN 2/3 is sent to Channel 2/3.
If this button is pressed, the signal coming from the computer to the USB interface is sent to
Channel 2/3.
connectionS, CONtROLS, AND INDICAtORS:
9
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
DEUTSCH
ENGLISH