Legrand 895 Series Floor Box Covers v.1 - Manual

895/896 Series
Floor Box Covers
INSTALLATION INSTRUCTIONS
Installation Instruction No.: 1 003 789 R1 – Updated August 2005
Walker ® electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Walker electrical products
may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
Products Covered: 895DCC, 895, 895T, 895SP, 895TSP, 895P, 895GFI, 895TGFI, 896CK, 896TCK, 896PCK, 895TAL, 895TCAL, 895GFICAL,
895TGFIAL, 895SPCAL, 895TSPAL, 896CKAL-1/2, and 896TCKAL-1/2 Covers
IMPORTANT: Please read all instructions
before beginning.
881 PVC Floor Box Applications:
Step 1 Remove protective concrete
cap from box.
Step 2 For dual service applications, slide
partition onto the slots located on
the inside of the box and mark the
partition 2
" [50mm] below the top
of the box. Volume of power
compartment is reduced by
the first legible calibration.
Step 3 Remove the partition and break off
the top portion at the first calibration
below the mark made from step 2.
Reinstall the partition with the
small compartment being the
communications side.
Cover Attachment:
Step 4 Attach receptacle to cover adapter and wire the device.
Cat. No. 895DCC
(Shown)
Step 5 Place the gasket support plate over the receptacle and
attach with a #6 round head screw.
Step 6 Place the gasket over the support plate and attach the
cover with (3) #8 flat head screws.
Step 7 Remove 1/2 " trade size screw plug and pull communication
cables through the opening (895DCC only). Complete
installation by aligning the adapter with the box grooves
in the box and push into place – No glue required!