Legrand 881AMD8TC User Manual

Ratchet-pro slide cover

Advertising
background image

Ratchet-Pro Slide Cover

I N S T A L L A T I O N I N S T R U C T I O N S

Installation Instruction No.: 1 003 720 R2 – Updated May 2009

Wiremold/Legrand electrical systems conform to and should be
properly grounded in compliance with requirements of the current
National Electrical Code or codes administered by local authorities.

All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold/Legrand electrical
products may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the
National Electrical Code.

Products Covered: 881AMD8TC, 897CTC, 897CFFTC, 881CTC, 881RC4TC, 881AV3CTC, 8814FFCTC

899CTC & 881CM2TC – For use in 4 1/2" [114.3mm] minimum concrete pours.

1. Remove protective concrete cap

from box.

3. Remove the partition and break off

the top portion at the first calibration
below the mark made from step 2.
Reinstall the partition with the small
compartment being the
communications side.

2. For dual service applications, slide

partition onto the slots located on the
inside of the box and mark the partition
2" [51mm] below the top of the box.
Volume of power compartment is
reduced by the first legible calibration.

IMPORTANT: Please read all instructions

before beginning.

For use in 4 1/2

"

[114mm] minimum concrete pours.

CAUTION: Do not operate tile stripper or resurfacing equipment over top of cover.

This may result in damage to the surface finish of the product.

FLOOR BOX PREPARATION:

881AMD8TC/881CTC/881AV3CTC COVER INSTALLATION

3. Connect receptacle leads to circuit

conductors with twist-on wire
connectors or other approved
methods.

WARNING: Receptacle mounting means not grounded. Grounding

wire connection required. For isolated ground wiring,
connect ground leads to a separate isolated grounding
conductor (see NEC 250-146(d)).

1. Cut a 6 1/2" [165mm] circular

concentric opening in the floor
covering.

2. Remove the slide cover and gasket

to access the communications
compartments.

Advertising
This manual is related to the following products: