Legrand RC3 Receptacle Replacement - Manual

RC3, RC7 & RC4
Receptacle Replacement
INSTALLATION INSTRUCTIONS
Installation Instruction No.: 1 003 786R1 – Updated October 2003
Products Covered: RC37REC, RC4REC2, RC37REC-25 and RC4REC2-25
IMPORTANT: Please read all instructions
before beginning.
Walker ® electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Walker electrical products
may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
Step 1 Remove junction box cover and disconnect wires. Step 2 Remove slide holder and scrub water gasket.
Step 3 Use screwdriver to disengage snap fingers. Move
screwdriver to the outside and pull up. Repeat on
the other side of the receptacle.
Step 4 Remove receptacle from assembly.
For RC3TC & RC7TC Series Devices
For use with: RC3TC, RC7TC, and RC4TC Series Poke-Thru Devices
CAUTION: De-energize circuit before removing
junction box cover.