Legrand 2400 Series Steel Plugmold Multioutlet System v.2 User Manual
Page 2
Wiremold / Legrand
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX 905-738-9721
© Copyright 2008 Wiremold / Legrand All Rights Reserved
END FEEDING 24R PLUGMOLD
Step 1 Mount 2400 box or 2410C entrance end
fitting to the wall.
Step 2 Connect 24R Plugmold base to box or
entrance end. Mount the 24R Plugmold
base to the wall using No. 8 flat head screws.
Step 3 Cap wire at the end of the harness on the
non-feed side using wire nuts.
Step 4 Snap 24R Plugmold cover onto the base.
Step 5 Cut and strip wires in appropriate location.
Connect feed wires to the harness using
wire nuts or W30 Connectors. (Wire Nuts and
W30 Connectors are sold separately.)
COUPLING AND CUTTING 24R PLUGMOLD
Coupling – 24R Plugmold may be coupled
using 2401 Couplings.
Cutting
– 24R Plugmold may be cut to length.
If 24R Plugmold is cut a 2409 grounding
clamp must be installed in each section
of 24R Plugmold. 24R Plugmold has
one 2409 factory installed per section.
Additional 2409 may be purchased
separately.
1 007 574 0208