Installation and operating instructions – Louroe Electronics MLA-8 User Manual

Page 3

Advertising
background image

OUTPUT CONNECTION FROM MLA-8 MIXER TO LOUROE BASE STATION

(Note: Power supply of the MLA-8 must not be used when connecting to a Louroe base station if the
distance is less than 1000’.)

MICROPHONE CONNECTION:

Located at the bottom of the PC Board is a single 3-pin terminal block marked “AUDIO OUT” and

contains three pins marked A, B, C using the shielded portion of recommended cable connect as
follows:

Red wire goes to Pin “A” (12Vdc)
Black wire goes to Pin “B” (Audio Output)
Bare wire goes to Pin “C” (ground)

SPEAKER CONNECTION:

Applies only if speaker/microphones are being connected. If remote units are microphones only, skip

this step and use the recommended cable shown in page 1.

The speaker input connection utilizes the 2-pin terminal block marked “SPEAKER”.

Pin marked “SP” of MLA-8 (green wire) connects to Pin “SP” also of terminal block at the base
station
Pin marked “G” of MLA-8 (white wire) connects to Pin “G” of terminal block at the base station


For connections to the speaker inputs of the Louroe base station, please refer to the specific
installation instructions for that model.

OUTPUT CONNECTION FROM MLA-8 MIXER TO OTHER RECEIVING DEVICES SUCH AS

DVRS, ETC.

(Note: Power supply of the MLA-8 must be used when connecting to receivers other than Louroe base station

Using the recommended cable (2 Cond. Shielded 22 AWG) see page 2 for connecting the microphone

to the input terminal blocks (Zone 1 to 8) MLA-8, matching Pin A to A, B to B and C to C.

The MLA-8 has 2 types of audio outputs.

When using the 3-pin terminal block, connect 2 wires to Pin B and Pin C. Pin B is positive audio which

can be connected to the positive of the audio input of the receiving device. Pin C is ground and can be
connected to the ground of the audio input of the receiver.

The other output is an RCA jack which can be connected to an RCA type input of the receiving device.

Plug in power supply (included) to +12Vdc power jack.

Page 3 of 8

LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406

TEL (818) 994-6498

FAX

994-6458

website: www.louroe.com e-mail: [email protected]

(818)

®

INSTALLATION AND OPERATING INSTRUCTIONS

mla_6/8_inst_3/15

Advertising
This manual is related to the following products: