Louroe Electronics MS-1 User Manual
Ms-1, Description, Operation
DESCRIPTION
The MS-1 Mute Switch is an accessory to Louroe Audio Monitoring/Audio Surveillance Systems when microphone
muting is required. The MS-1 contains a built-in rocker switch mounted to a single gang stainless steel face plate. This
is to mute or disable the audio feed to a base station or other receiving and recording devices. It prevents the operator
from listening in to the microphone when it is not needed, The MS-1 fits into a single gang backbox (not included) for
mounting to a wall or flat surface.
OPERATION
A rocker switch is mounted to a single gang stainless steel face plate. Top part of switch is marked MICROPHONE ON
WHEN ILLUMINATED. Lower part of switch is marked MICROPHONE OFF.
When the Top part of the rocker switch is pressed to MICROPHONE ON WHEN ILLUMINATED, the rocker switch
illuminates RED, indicating that the microphone is active and will pick up sounds within it’s range.
When Lower part of the rocker switch is pressed in to MICROPHONE OFF, illumination turns OFF, indicating that the
microphone is muted and no sound is produced.
MODEL MS-1
2 Conductor shielded cable, 22
gauge with a 24 gauge drain wire
NOTE:
Unshielded cable is not
satisfactory for audio systems
WIRING REQUIREMENTS
West Penn 452 or equivalent
MS-1
MUTE SWITCH
INSTALLATION AND OPERATING INSTRUCTIONS
6955 VALJEAN AVE, VAN NUYS, CA 91406
PH: (818)994-6498 / FAX: (818)994-6458
/ www.louroe.com
®
Page 1 of 8
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406
TEL (818) 994-6498
FAX
994-6458
website: www.louroe.com e-mail: [email protected]
(818)
®
ms_1_inst_3/15