Lynx Studio Hilo Version 5 Firmware User Manual
Page 5
1.2.2.3 Active Channels Shown on Output Mix Routing Page
Improvements have been made that allow this page to accurately show the active inputs and outputs available in real
time.
When Hilo is in 8-channel LT-USB Mode, USB channels
1-8 are visible and available.
When the Optical Out Mode is set to ADAT, Out 1-8 are
available. Note - when one wishes to use ADAT I/O, it
would be more typical to select 16-channel mode, so that
the ADAT channels can be independent from the other
Hilo outputs.
Also Note – when the Optical Out Mode is set to ADAT,
the S/PDIF Optical Output is grayed out and not
available. However the SPDIF Coax Output is still
available for use.
When the 16-channel USB Mode is engaged, all 16 USB
input and output channels are visible and available.
If ADAT is detected on the optical input, the ADAT
inputs are visible and available.