Maytag MSD2434HEQ - Manual (Page 5)

4
Spill-Catcher ™ Shelves (select models)
Spill-Catcher ™ shelves have a spill retainer edge to
contain spills and make cleanup easier.
Some Spill-Catcher ™ shelves feature the Easy Glide
slide-out feature. To slide out, grasp the front of the
shelf and pull forward. Push the shelf in to return to
original position.
WARNING — Never attempt to adjust
a shelf that is loaded with food (except in
the case of the Elevator
™ shelf).
Elevator ™ Shelf (select models)
The Elevator ™ shelf is equipped with a spill-retaining
edge and the Easy Glide slide-out feature. It can be
adjusted up or down without unloading. To slide out,
grasp the front of the shelf and pull forward. Push the
shelf in to return to original position.
To adjust the Elevator ™ shelf: Pull out the knob on the
crank handle. Rotate the crank clockwise to raise the
shelf, and counterclockwise to lower the height of the
shelf.
To remove: To remove the Elevator™ shelf for
occasional cleaning, completely unload the shelf and
pull the shelf forward. When the shelf stops, press up on
the tabs located underneath its outside edges, then
continue pulling forward, clear of the frame.
To replace: Align the shelf to the frame and push it all
the way back. It is not necessary to press up on the tabs
for reinstallation.
In ordinary use, the Elevator ™ shelf frame assembly does
NOT require removal. Though unlikely, and not
recommended, the correct removal procedure is as
follows:
• Unload the shelf completely.
• Slide the shelf forward about two inches and
manually move the two rear latches toward the shelf
center.
• While supporting the entire shelf and frame from
underneath, lift slightly and rotate the assembly
approximately 30° to allow the rear mechanism to
clear the vertical rear side rails.
• The entire assembly can then be moved forward and
clear of the refrigerator compartment.
• To reinstall, reverse the removal procedure. Be sure
the shelf is in a level position. When the sliding
shelf is pushed to the rear, it will reposition the rear
latches to their correct operating position.
Fresh Food Compartment
Tempered Glass Cantilever Shelves
These shelves are adjustable so the refrigerator interior
can be customized for varying food storage needs.
Interior Features
To remove a shelf: Unload. Lift up the rear of the shelf
slightly, pull the shelf straight out.
To move a shelf to a different position: After
removing, tilt up the front edge of the shelf. Insert the
hooks into the desired openings and let the shelf settle
into place. Be sure the shelf is securely locked at the rear.
style may vary