MBM Corporation TRIUMPH 721-06 LT - Manual (Page 20)

- 20 -
IDEAL 7228-06 LT
P S F1
F2
F3 I D
CP AM E
PROGRAMM STEP
2000
1750
1500
1250
1000
750
500
250
7 8 9
4 5 6
1
0
M
C
Stop
M
E
S
Start
2 3
• Operation •
Eject function
If button z U is pressed the backgauge will
advance to the preset measurement, ejecting
the material to be cut, then automatically return
to the position shown on the display.
Adjust the eject-dimension
• Press p and hold + press z
e
on display.
• Insert the desired dimension.
•
g Store dimension.
Multiple cut
• Enter the multiple cut size on the display W.
• Advance to the measurement with the S
button.
• Push the paper to the backgauge C .
• Release the cut.
• Press
Q
button "A" on the display K
• Enter the multiple cut size.
• Press S button backgauge will advance
by the multiple cut size.
• After cutting the backgauge will advance by
the multiple cut size.
• Pressing the s button shows the actual
size.
If, when inserting the multiple cut size, the T
button is pressed instead of the
Q
the LED "M
"
L will light and after every cut the S button
must be pressed.
Exiting program-mode
• Press T button LED "M " L is cleared on
the display. The actual size is shown.
Cutting activation
Warning!
• Run backgauge to the front for turning the
paper stack.
• Do not interrupt the upward movement of the
blade by performing switching procedures.
• Release blade only when LED "S" N has
gone out.
• The safety area must be free.
• Blade must always be at the top and be
covered by the clamp. Do not touch the blade
risk of injury!