Measurement Computing WBK Options - Manual (Page 180)

Connecting to the Device Interface Side – WBK41 System Examples
WARNING
Electrical Shock Hazard! To avoid possible injury and equipment damage, turn off power to
devices and connected equipment prior to setup.
Channel Input Side Device Interface Side
A WaveBook/516E with a WBK41, two DBK84 Modules, & three DBK21 Cards (in a DBK10)
Device Interface Connections (seen in the above example):
1. From the WBK41 P1 connector to two DBK84 Modules via two CA-37-1T Cables.*
2. From a WBK41 SYNC port to a WaveBook/516E SYNC Port via CA-74-1 Cable.
3. From the WaveBook/516E EXPANSION port to the WBK41 PARALLEL PORT via a
CA-35-12 cable.
4. From the WaveBook/516E ETHERNET port to the Ethernet via a CA-242 cable.
5. From the WBK41 P2 connector to three DBK21 Cards (in a DBK10 Chassis) via a
CA-37-3 cable.
6. Power Supply – a TR-40U was connected to the POWER IN [DIN 5] connector to supply
power at +10 VDC to +30 VDC for each of the following devices:
•
• WBK41
WaveBook/516E
* Information regarding the use of CA-37-T cables is provided on page 10.
Using Fastener Panels to Stack Modules:
Fastener Panels are discussed on page 7.
Note 1
3 DBK21 Cards in a DBK10
DBK84
DBK84
WBK41
WaveBook/516E
Note 1: Each DBK84 module requires a unique address setting as explained on page 13 of this document
module and in the DBK Options User’s Manual (p/n 457-0905). Each DBK21 card also requires a
unique address as dicsussed in the DBK Options User’s Manual.
Thermocouple & Multifunctional Modules 926896 WBK40 & WBK41, pg. 11