MEGAPOWER MVP-736 - Manual (Page 4)

Power Adaptor
Use only the power adaptor supplied with the Digital Presenter. Do not use the power
adaptor if it has become damaged or frayed. For a replacement power adaptor, contact
your authorized dealer.
Do not allow anything to rest on the power adaptor. Do not place this projector where the
cord may be abused by persons walking on it.
Grounding
This Digital Presenter is grounded through the conductor of the power cord. To avoid electric
shock, plug the power cord into a properly wired receptacle. Do not defeat the safety purpose
of the grounding type plug.
Overloading
Do not overload wall outlets and extension cords as this can result in the risk of fire or electric
shock.
Cabinet Slots
Never insert objects of any kind into the Digital Presenter through cabinet slots as they may
touch dangerous voltage points or short out parts that could result in a risk of fire or electric
shock.
Liquid Spills
Do not set drinks or other liquids on top of the Digital Presenter. Do not place the Digital
Presenter near water, for example, near a bathtub, washbowl, kitchen, sink, or laundry tub, in
a wet basement, or near a swimming pool. Spilled liquids can flow inside the Digital Presenter
and cause damage.
Repair
Do not disassemble the Digital Presenter. Take it to an authorized technical staff when service
or repair work is required. Opening or removing the cover may expose you to dangerous
voltages or other risks. Incorrect re-assembly can cause electric shock when the appliance
is subsequently used.
Technical Service
Unplug this Digital Presenter from the wall outlet and refer servicing to authorized technical
staff under the following conditions:
1. When the power adaptor or plug is damaged or frayed.
2. If liquid has been spilled into the Digital Presenter.
3. If the Digital Presenter has been exposed to rain or water.
4. If the Digital Presenter does not operate normally by following the operating instructions.
Adjust only those controls, which are covered by the operating instructions. Improper
adjustment of other controls may result in damage and will often require extensive work
by the authorized technical staff to restore the Digital Presenter to normal operation.
5. If the Digital Presenter has been dropped or the cabinet has been damaged.
6. If the Digital Presenter exhibits a distinct change in performance.
2 13
Chapter 4
Care and Maintenance
4.1 Cleaning the Digital Presenter Housing
DO NOT try to service the Digital Presenter. Except for the lamps, the interior of the Digital
Presenter contains no user-serviceable parts. Refer all Digital Presenter servicing to your
dealer. Failure to do so can result in serious personnel injury or damage to the Digital
Presenter.
DO NOT clean the housing with organic solvents, such as those containing acetone. Wipe
the exterior of the housing wiht a soft, damp cloth. Protect the Digital Presenter from rain,
snow or extreme temperature.
The information in this chapter describes how to care for and prevent accidental damage to
your Digital Presenter . You should treat your Digital Presenter with the same care you would
give to any other valuable equipment.
4.2 Cleaning the Camera Lens
To clean the camera lens:
1. Remove the lens cover and set it aside.
2. Apply a non-abrasive glass cleaner to a soft, dry cleaning cloth. Be careful not to use
exessive amount of liquid glass cleaner. Also, do not use abrasive cleaners, solvents,
or other harsh chemicals that might scratch the lens.
3. Lightly wipe the cleaning cloth over the lens from center to the edge in circular motion.
4. Replace the lens cover.
4.3 Transporting the Digital Presenter
The Digital Presenter is a highly sophisticated piece of electronic equipment that is sensitive
to impact, excessive heat, cold and humidity. When transporting the Digital Presenter, use a
protective carrying bag or use the original packing carton to minimize shock and impact.
Store and transport the Digital Presenter at temperature between 0 and 140 degrees
Fahrenheit (-17 to 60 degrees Centigrade). Avoid storage in automobiles during seasonal
temperature extremes. Automobile interior temperatures can exceed 160 degree Fahrenheit
(70 degrees Centigrade) in summer. If the Digital Presenter has been exposed to extremely
hot, cold or humid conditions, allow it to stand at room temperature for 30 minutes befroe use.