Meinberg SyncBox PTPv2 - Manual (Page 16)

If there is a DHCP (Dynamic Host Configuration Protocol) server available in your
network, the LANTIME system can obtain its IPv4 settings automatically from this
server. If you want to use this feature (again, you should ask your network
administrator whether this is applicable in your network), you can change the DHCP
Client parameter to “ENABLED”. Using DHCP is the default factory setting.
If the DHCP client has been activated, the automatically obtained parameters are
shown in the appropriate fields (IPv4 address, netmask, gateway).
Configuration: Local
In the Local section you can activate an reboot of the SyncBox and set up a new
password for the only user “root”.
16