Microcom 405 - Manual (Page 3)

405 Addendum to 410 Operators Manual
405 Addendum to 410 Operators Manual 2
1.3 SPECIAL STATUS LIGHT/TONE INFORMATION
The status light has different functions depending upon the mode of the printer. Table 1 shows
the relationship between the status light and the different modes.
Status Light/Tone
Light
Color
Tone Mode Meaning
Green None All On-Line and ready to print
Green Double tone
before print
All Battery is low, recharge the printer. At this
point the battery is at approximately 10% of its
capacity and can print less than 1000
additional linear inches.
Red None All Printer error:
Caused by a paper-out condition or a
hardware failure. If paper is out, follow
instructions in section 2.3, otherwise turn
printer off and back on. If condition persists,
contact your service representative.
Flashing
Red
Continuous
Tone
All The battery pack is too low for proper printer
operation. The unit will remain in this mode
until the battery is recharged or the printer is
powered off.
Yellow None Tag/tear,
Peel
Label present. Label is ready to be removed
from the printer mouth.
Flashing
Yellow
None Batch Printer is in standby mode and waiting for the
front panel button to be pressed.
Flashing
Yellow
None After
Paper-Out
Printer is waiting to continue processing. The
label button must be pushed twice to clear
yellow after loading.
Table 1