MicroE Mercury II 6000 - Manual (Page 50)

PurePrecision Laser Tape II Scale Installation
IM-Mercury_II_PurePrecision_Scales Rev. 1 Page 6 ©2014 MicroE Systems
Mercury II PurePrecision Tape and Glass Scales
Installation Manual and Reference Guide
3.1.4 Design Guide
The following table describes the three basic mounting configurations for tape scale installation.
Also, see all guidelines that follow the table.
# Type of Installation Example
1 Machined Edge: Trench - Hand
Application Only
Trench:

6.1mm trench: applicator tool is not
compatible with 6.1mm trench, and
end caps cannot be used.

Max radius of 0.13mm required
between scale benching edge and
bottom of trench.

Benching edge must be parallel to
axis of motion to within .05/100mm.

Trench surface flatness to within
.003/10mm.
2 Machined Edge: Trench - Use with Tape
Applicator Tool
Trench:

12mm trench.

Max radius of 0.13mm required
between scale benching edge and
bottom of trench.

Benching edge must be parallel to
axis of motion to within .05/100mm.

Trench surface flatness to within
.003/10mm.
3 Temprary Straight Edge – Use with Tape
Applicator Tool
Temporary straight edge:

Use either your hands or the
applicator tool to install the tape scale
against a straight edge.

Minimum height of 9.53mm.

Benching edge must be parallel to
axis of motion to within .05/100mm.

Trench surface flatness to within
.003/10mm.

4.18±0.05mm: offset from tape scale
to temporary straight edge.
Guidelines:

MicroE Systems recommends using an edge as a guide to maintain straightness of the scale
during mounting. The edge can be temporary or permanent but must follow above guidelines.

Use the applicator tool for installation of scales, especially longer than 250mm, and for all
installations against a straight edge. For shorter scales, install by hand or use the applicator tool.
0.76±0.05mm
Scale Benching Edge
Trench
Scale Benching Edge
Trench
Min. 9.53mm
Temporary Straight Edge
Tape Scale/Marker Tape
6.10mm+0.10/-0.00
0.76±0.05mm
≥12.00mm
4.18±0.05mm
Surface Flatness