Microsens MS655099 User Manual
Page 24
20
4. Power on the Industrial switch converter. How to wire the power; please
refer to the Wiring the Power Inputs section. The power LED on the
Industrial switch converter will light up. Please refer to the LED Indicators
section for meaning of LED lights.
5. Prepare the twisted-pair, straight through Category 5 cable for Ethernet
connection.
6. Insert one side of Category 5e or above cables into the Industrial switch
converter Ethernet port (RJ-45 port) and another side of category 5e or
above cables to the network devices’ Ethernet port (RJ-45 port), e.g.
switch, PC or Server. The UTP port (RJ-45) LED on the Industrial switch
converter will light up when the cable connected with the network device.
Please refer to the LED Indicators section for LED light meaning.
Note
Be sure the connected network devices support MDI/MDI-X. If it does
not support, then use the crossover category 5e/above cable.
7. When all connections are all set and LED lights all show in normal, the
installation is complete.