MK Products Cobra Gold Gooseneck - Manual (Page 15)

Cobra Gold Owner's Manual - Page 10
Section D Maintenance
Periodic Maintenance
Maintenance of the torch will normally consist of a general cleaning of
the wire guide system, including tubes, drive rolls, and conduits at regular
intervals.
Remove spatter build-up from inside of nozzles with a hardwood stick.
The only parts on the Cobramatic system that are subject to normal wear are
the conduit, contact tips, gas cups, front body liners, wire guides, drive and
idler rolls. A supply of these parts should be maintained on hand.
If repairs do become necessary, qualified shop maintenance personnel can
easily replace any part.
Your Cobramatic System is designed to provide years of reliable service.
Normal wear and component failure may require occasional service.
The number of units in operation and the importance of minimal “down time”
will determine to what extent spare parts should be stocked on hand. See the
“Recommended spare parts list” for the most commonly replaced parts.
The front tube alignment is set at the factory for proper operation. If you
feel you that your torch is not performing properly see the photo below to
check alignment.
When replacing the Electrical Cable on a Cobra Gold make sure to properly
place the connectors back into the handle opening above the potentiometer
assembly. Use the picture below as a guide for proper placement.